• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Assignment Questions - 14209_467
Assignment Questions - 14209_469

Photography (Basic) - Introduction to photography and other graphic techniques
Page Navigation
  440    441    442    443    444  445  446    447    448    449    450  
9-31. In hand processing, the term "pull" refers to what action? 1.    Pulling the print through the entire process 2. Removing the print from the developer  prematurely 3.    Pouring  chemical  solutions 4.    Removing prints from the dryer 9-32. A negative with normal contrast was printed with a No. 4 printing filter. Which of the following statements  best  describes  the appearance of the prints? 1.    The number of tones, reproduced matches   the original scene tones closely 2.    The print shows an abundance of middle tones with few shadow areas 3.    The print is very flat 4.    The print has high contrast 9-33. When developing prints in a tray, you should ensure they are agitated in what manner? 1. Frequently 2.    Intermittently 3.    Constantly 4.    Infrequently 9-34. Which of the following statements is most accurate regarding print quality? 1. Print quality depends upon correct  exposure  only 2. Print quality depends upon correct  development  only 3.    Print quality depends upon correct exposure and development 4.    Print quality is governed by the  working  characteristics of the paper and developer 9-35. You are hand processing a single black-and-white  print. The print should be treated in the stop bath for what number of seconds? 1. 20 2. 15 3. 10 4. 5 9-36. What is   the most probable result of a fixing bath that is diluted less than  recommended? 1. The prints sink 2. The  prints  float 3. The  prints  blister 4. The  prints  separate from the base 9-37 . When  hand  processing  photographic film and paper, it is common practice  to  work  in  what  direction? 1. From right to left 2. From left to right 3. From top to bottom 4. From bottom to top 9-38. You are hand processing 26 8x10- inch prints at one time in a tray. You should agitate the prints in what  manner? 1. Move the bottom print to the top of the stack 2. Move the top print to the bottom of the stack 3. Turn all the prints at one time and fan them quickly 4. Remove each print in succession from the developer, drain it for  5  seconds,   then place the print at the bottom of the stack 9-39. You  are  processing  several  black- and-white prints at one time. You should treat the prints in the stop bath for what number of seconds? 1. 15 2. 30 3. 60 4. 90 68







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.